Question: I need to design a three - phase, half - wave controlled rectifier with a variable source, fixed load ( such as a resistor )

I need to design a three

-

phase, half

-

wave controlled rectifier with a variable source, fixed load

(

such as a resistor

),

and fixed output voltage, using PI control in PSIM. In the PSIM simulation, it

s important to note that the source varies at certain intervals, but the desired load voltage should remain constant. The attached pictures represents my current design and the output signale, but it appears to be incorrect. Could you provide a circuit diagram for the design in PSIM or MATLAB?

(

urgent

)

I need to design a three - phase, half - wave

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Hello, I need to design a three - phase, half - wave rectifier with variable source, fixed load, fixed output voltage, and PI controlled rectifier using PSIM. But I can make design the PI controller...

Whenever a lab asks you to assemble a circuit, and measure some quantities, implement (capture) the circuit in MultiSim, and use its simulation tools to gather the measurements. Rectification is the...

1. Define organization Behavior. 2. List the types of personality. 3. Difference between emotional intelligence and emotional Labour. 4. What do you understand by group dynamics? 5. Define...

Electronic Analogue Images of the circuits and waves in multisim are required Design a DC power supply with all stages: as shown in the attached figure 1 ( IC regulator LM7805 ,LM7812) FIGURE 1...

A single - phase full bridge inverter circuit, has load R = 2 and de source V s = 2 3 0 V . Find the value of power delivered to the load in watts only due to the fundamental component of the load...

Hello, you already did chapter 1 and 2 of my MASTERS Thesis already for me. (See attached) So normally you know masters thesis consist of 5 chapters right ??..... But in this case my thesis will be 4...

1.2. 2.1. 2.2. 2.3. 2.4. 2.5. To obtain the output waveforms of a three-phase full wave full-controlled rectifier for different firing angles. To analyse the output waveforms and determine output...

Electronic Analogue Design a DC power supply with all stages: rectification, filtering, regulation. Prepare the calculations that correspond to each case according to the values in Table 1 1) The...

I need to design any three - phase, half - wave controlled rectifier with variable source, fixed load ( like resistor ) , fixed output voltage, and PI in PSIM. What should be noted here is that in...

A servo motor (or "servo") is a continuous DC motor packaged together with reduction gears, a potentiometer to measure rotation, and electronics connecting the potentiometer output to the motor drive...

A 12.8-m W laser puts out a narrow beam 1.75 mm in diameter. What are the average (rms) values of E and B in the beam?

Xie Company identified the following activities, costs, and activity drivers for 2015. The company manufactures two types of go-karts: Deluxe and Basic. Required: Compute activity rates for each...

The validity of a test indicates Whether there is aqreement about its purpose. herrewalstered the wores are. whether it can be directly connected to tresterent. how eel it meanures what it is...

. (a) Pronghorn Restaurant accepted a Visa card in payment of a $150 lunch bill, The bank charges a 4% fee. What entry should Pronghorn make? (b) Culver Company sold its accounts receivable of...