I want matlab code which fetch data from the inventor file and do calculation of load failure $.$At model scale, the bridge will need to:

Span a gap of $550mm.$

Provide sufficient space to pass a pair of sewer pipers that have an outside diameter of $60mm.$ Note that the

pipes cannot be used to support the bridge.

Be simply supported by resting on two cylinders $($approximately $30mm$ in diameter$).$ In other words, the

bridge must rest on the top of the supports as shown in the figure below $($no bracing against the supports at

an angle$).$

Support a point load applied at the center of the bridge using a Hounsfield Universal Testing machine. A flat

metal spreader plate will be placed on top of each of the cylindrical supports and the load point to spread the

load and prevent indentation.

The bridge must not be wider than $90mm.$

To simulate the ability for cars to move through it$,$ a $5050400mm$ block must fit through the bridge $($i$.$e$.$

no cross bracing$)$

Write a matlab code to calculate the failure based on the inventor file