Question: If the maximum frequency deviation is 25kHz and modulating signal frequency is 12kHz. 6c. Is this FM treated as narrow band or wide band? wide

If the maximum frequency deviation is 25kHz and modulating signal frequency is 12kHz. 6c. Is this FM treated as narrow band or wide band? wide band, base band, narrow band

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Physics Questions!

Gamma rays were first observed by the to detect defects in casts, molds, and metal French chemist Paul Villard (1860-1934) sheets. It can also be used as a thickness in 1900 when he was investigating...

04:- By using Armstrong method design Wide Band FM with carrier frequency 90 MHz and frequency deviation equal 14.4KHz from narrow band FM with carrier frequency 150KHz and frequency deviation to...

instructions Instructions Answer the following on a clean sheet of paper. Take a photo of your answer sheet then upload here. {4 items it 5 points) i. There are stations having the maximum frequency...

b. The government offers the license to one company to build a Frequency Modulation (FM) broadcast station to the newly developed area. Upon checking with the available frequency band ranging from 88...

Please do it using MATLAB 1. First, generate an FM signal using the parameters given in Table 1 and the FM Modulated wave equation given below: y(t) = A cos(2 fet + 27 Af i Im(T)dr), (1) where Im(t)...

A carrier is frequency modulated with a sinusoidal signal of 2 kHz , resulting in a maximum frequency deviation of 5 kHz . ( a ) Find the bandwidth of the modulated signal. ( b ) The amplitude of the...

Exercise 1: A given FM signal has a maximum frequency deviation of 25 HZ for a modulating sinusoid of unit amplitude and a frequency of 100 kliz. Find the required value of frequency multiplication n...

please solve and explain whole question 2 in detail, thank you very much. Q2. (a) An angle-modulated signal is described by xc(t) 50cos[2T (108)t 3 sin(2T (103) t] (i) Consider xe(t) is a Phase...

(25 pts) An angle modulated signal is given by u(t)=10cos(2106t+23sin(2104t)) If the message signal has a unit amplitude, a. Find the message signal for both when the signal is FM and PM modulated (3...

The government offers the license to one company to build a Frequency Modulation (FM) broadcast station to the newly developed area. Upon checking with the available frequency band ranging from 88...

On June 30, 2017, Utusivik's equity section was as follows: Preferred shares (500,000 shares authorized, 25,000 outstanding)...$ 2,000,000 Share capital (5,000,000 shares authorized, 1,000,000...

Three dimensions three point particles are fixed in place in a xyz coordinate system. Particle A, at the origin, has mass mA. Particle B, at xyz coordinates (2.00d, 1.00d, 2.00d), has mass 2.00ma,...

1 - If Milo Co . reports income applicable to ordinary shares of 9 0 0 , , 0 0 0 and preferencedividends of 6 9 , 3 7 5 for the year ending December 3 1 , 2 0 1 9 . Basic Earnings per share for 2 0 1...

REVIEW THE INFORMATION ABOUT LEAPFROG HOSPITAL SAFETY GRADES. CHOOSE TWO HOSPITALS TO COMPARE A VERY EFFECTIVE ONE AND ONE WHICH IS NOT EFFECTIVE. WHAT SEPARATES THE TWO? HOW CAN THE A HOSPITAL USE...

6. How can a message directly influence the interpreter?

1. Discuss the following statements: (a) The dangers of mountain driving in an old Lada 4 4, and safety concerns. (b) We perceive the world backwards. (c) Numbers are different from words, but they...

5. How can a sender (utterer) directly influence the interpreter (receiver)?