Implement the network shown in the above figure using Packet tracer and configure the IP addresses of the interfaces and the required static routes such that all the subnets are reachable from each other. What do you need to submit for this problem? A submission of a packet tracer, Lastname_Mini_Project1_Static_Routing.,PKZ, file of the entire network that you configured using static routing.

Sol58:

1. Assign IP addresses to each interface of the routers according to the network topology.
2. Determine the subnet masks for each subnet based on the number of hosts required.
3. Configure static routes on each router to allow traffic to flow between subnets.
4. Verify connectivity between all subnets by pinging from one subnet to another.

To configure static routes on each router:

1. On Router1, add the following static routes:

• Destination Network: 192.168.2.0, Subnet Mask: 255.255.255.0, Next Hop: 192.168.1.2
• Destination Network: 192.168.3.0, Subnet Mask: 255.255.255.0, Next Hop: 192.168.1.2

1. On Router2, add the following static routes:

• Destination Network: 192.168.1.0, Subnet Mask: 255.255.255.0, Next Hop: 192.168.1.1
• Destination Network: 192.168.4.0, Subnet Mask: 255.255.255.0, Next Hop: 192.168.1.1

1. On Router3, add the following static routes:

• Destination Network: 192.168.1.0, Subnet Mask: 255.255.255.0, Next Hop: 192.168.2.2
• Destination Network: 192.168.4.0, Subnet Mask: 255.255.255.0, Next Hop: 192.168.2.2

1. On Router4, add the following static routes:

• Destination Network: 192.168.2.0, Subnet Mask: 255.255.255.0, Next Hop: 192.168.2.1
• Destination Network: 192.168.3.0, Subnet Mask: 255.255.255.0, Next Hop: 192.168.2.1

Once these routes have been configured, each subnet should be able to communicate with the others.

A submission of a packet tracer, Lastname_Mini_Project1_Static_Routing.,PKZ, file of the entire network that you configured using static routing.

You need to submit a packet tracer file with the name "Lastname_Mini_Project1_Static_Routing.PKZ" which should contain the entire network that you configured using static routing. This file should be submitted in a format that is specified by your instructor or institution. Make sure that the file is complete and all the required components of the network are present and configured correctly.