Question: In a stopwatch time study, the average time it takes a given worker to perform a task a certain number of times, without correction for

In a stopwatch time study, the average time it takes a given worker to perform a task a certain number of times, without correction for performance rating or allowances, is the

Question

18

options:

.

average observed time

.

standard time

.

performance rating time

.

normal time

.

allowance time

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

1. Which of the statements below best describes office layout ? Group of answer choices deals with low-volume, high-variety production addresses the layout requirements of large, bulky projects such...

Question 1 4 In a stopwatch time study, the average time it takes a given worker to perform a task a certain number of times is the: observed time normal time standard time allowance time performance...

In a stopwatch time study, the average time it takes a given worker to perform a task a certain number of times is the: Group of answer choicesstandard time.normal timeaverage time.professional...

TB MC Qu . 0 7 - 7 7 In a stopwatch time study, the average of . . . In a stopwatch time study, the average of the times recorded for a given worker to perform a given task is the: Multiple Choice...

In a stopwatch time study, the average of the times recorded for a given worker to perform a given task is the: Group of answer choices observed time. normal time. standard time. allowance time....

I know that you have a limited time, so beside answering them you can choose me a process which fits for this project. and from the steps to follow part, I know how to follow the steps but I don't...

please answer these questions 1. Measurements taken at various points in the transformation process for control purposes: are called: a) plans. b) directions. c) controls. d) feedback. 2. Which of...

Need answers of the Mcqs hich of the following is not typically part of a stopwatch time study to develop a standard time for a job? Multiple Choice Inform the worker who will be studied. Define the...

The following two videos depict this four - workstation process with a buffer with an increased capacity of two units, then four units. Click start to run these videos. As you observe these lines,...

QUESTION THREE Discuss the determinants of mortgage interest rates. (15 marks) Define anchor tenant and clearly give examples in some of Nairobi properties (excluding supermarkets). (10 marks) a) b)

Refer to the Kepler Company information as shown in Problem 16-45. Round all percentages to one decimal place. Required: 1. Express each item in the asset section of the balance sheet as a percentage...

Can you explain this general accounting question using accurate calculation methods? The following are budgeted data for Wilson Electronics: Each unit of production requires 2.5 pounds of raw...

2. The force of interest 8 is a function of time and at any time t, measured in years, is given by the formula: 8(t) = 0.02 +0.0020 8(t) = 0.03 +0.005t Osts5 5 st s 10 a) Calculate the discount...