Question: In a wire drawing process, the die angle and the coefficient of friction on the die - wire contact surface are such that B =

In a wire drawing process, the die angle and the coefficient of friction on the die-wire contact surface are such that B=1. If the applied tensile stress is equal to 0.8 times the yield stress, calculate the reduction in the crosssectional area of the wire.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

Forces and Newton's Laws of Motion 1) The figure shows top view of four forces acting on an object of mass 3.0 kg on a table. What is the magnitude and direction of the force F,, if the object...

Q:

CASE: Ohio Nail Manufacturing Introduction It was 1:30pm. Ed Heath, ONM's chief executive looked up from his desk to see his long-time colleague Mike Hesletine, the company's CFO, sitting patiently...

Q:

Problem 1: Consider the forces shown in the figure. Part (a) Find the magnitude ofthe force Fl shown in the figure in Newtons. Numeric : A numeric value is expected and not an expression. Part (b)...

Q:

8. A hot upset forging operation is performed in an open die. The initial size of the workpiece is: Dn=35mm, and ho0=70mm. The part is upset to a diameter D=60mm. The work metal at this elevated...

Q:

(Please open this question on desktop to view the photo as it sometimes doesn't show on phones, thanks!) Please solve the following and show the steps of how you solved it. Answers are included at...

Q:

1. Two horizontal forces, F, and F,, are acting on a box, but only F, is shown in the drawing. F, can point either to the right or to the left. The box moves only along the x axis. There is no...

Q:

Clearly hand.wri/te and show all steps 12. A 40-kg crate is being lowered with a downward acceleration is 2.0 m/s2 by means of a rope. (a) What is the magnitude of the force exerted by the rope on...

Q:

Manufacturing questions 7. The strength coeuclent =600 MPa and strain-hardening exponent = 0.32 for a certain metal. During a forming operation, the final true strain that the metal experiences...

Q:

Manufacturing A round cross section extrudate is produced from a billet 150mm length and 75mm in diameter through a direct extrusion operation with extrusion ratio rx=4.0. The dic angle (half-angle)...

Q:

9. A child projects his toy car up an inclined plane which makes an angle of 37 with the horizontal at a speed of 6.0 m/s. The coefficient of kinetic friction is 0.50. a. How far does the car go up...

Q:

What is the FUTA tax, and at what percentage is it assessed?

Q:

15. The average value of a half-wave rectified voltage with a peak value of 200 V is (5 Points) 63.7 V 127.2 V 141 V O V

Q:

BRRECMBC 9 1 8 . III . 0 1 9 . MI . Victor and Roberta Sanchez file jointly and had a combined income of $ 8 1 , 7 0 0 last year. They contributed $ 4 , 2 0 0 to their retirement plan and had...

Q:

PAD4204 Public Finance 1) Is property tax the only major, broad-based tax that falls on the value of wealth? TRUE OR FALSE 2) Is real property defined as being immobile and includes land, natural...