Question: In Table 5 0 4 . 3 , A designates the After construction height. Question 1 options: 1 ) True 2 ) False
In Table A designates the After construction height.
Question options:
True
False
Question points
In general, for Type I and Type II Construction, fireretardanttreated wood FRTW materials are allowable in roof construction.
Question options:
True
False
Question points
When exposed to heat an intumescent coating will shrink to form a tight fitting barrier around the structural member.
Question options:
True
False
Question points
In Type IA Construction when shall FRTW not be used in roof construction?
Question options:
FRTW is always allowed.
When Type IA construction exceeds stories above grade plane and the top floor to the roof is feet or greater.
When Type IA Construction exceeds stories above grade plane and the distance between top floor and the roof is less than feet.
In Type IA FRTW is never allowed.
Question points
A covered mall building with an area of square feet shall have an person per square foot occupant load not to exceed: Pick the closest answer.
Question options:
Question points
The interior finish of an Atrium walls or ceiling shall not be less than Class B
Question options:
True
False
Question points
When considering the fire rating of a floor one only needs to concerned with the floor finished surface.
Question options:
True
False
Question points
In general, in a building of Type IIIA construction, the primary structional frame shall have a fire resistance rating of hour.
Question options:
True
False
Question points
According to the table "Height and Area Limitations for Airport Traffic Control Towers," airport control towers built to Type IIIA standards may be feet in height.
Question options:
True
False
Question points
In Table B designates unprotected construction.
Question options:
True
False
Question points
In Table note d would allow an exterior wall's fire rating to be reduced by hour when an automatic sprinkler system is installed.
Question options:
True
False
Question points
In Type IV Construction, when there is a minimum horizontal separation of feet, wooden columns and arches are permitted to be used externally.
Question options:
True
False
Question points
Which of the following does not apply to a LiveWork occupancy?
Question options:
The livework space is not permitted to be not greater than square feet in area.
Not more than five nonresidential workers or employees are allowed to occupy the nonresidential area at any one time.
Not more than customers shall be allowed in the nonresidential areas for business purposes at any one time.
The nonresidential area is permitted to be not more than of each LiveWork unit.
Question points
The use of nonmetallic duct work, in Type I and Type II construction, is controlled by International Mechanical Code IMC
Question options:
True
False
Question points
From Table the separation required between a nonsprinkled S occupancy and a I occupancy is hours.
Question options:
True
False
Question points
In Type III and Type IV Construction, Fireretardanttreated wood FRTW is allowed in exterior walls with a rating of hours or more.
Question options:
True
False
Question points
In General, Type I and Type II Construction are considered noncombustible.
Question options:
True
False
Question points
When calculating a defined Gross Leasable Area the tenant storage areas are excluded from the calulation.
Question options:
True
False
Question points
When calculating the frontage factor W can never exceed
Question options:
True
False
Question points
The within each individual tenant space in a covered mall the distance of travel from any point to an exit or entrance to the mall shall not exceed feet.
Question options:
True
False
Step by Step Solution
There are 3 Steps involved in it
1 Expert Approved Answer
Step: 1 Unlock
Question Has Been Solved by an Expert!
Get step-by-step solutions from verified subject matter experts
Step: 2 Unlock
Step: 3 Unlock
