In this set up you will just manipulate the elements in the bar magnet tab and set the variable or elements in the pickup coil tab in a fixed value shown below. After setting the elements in the pickup coil, select the voltmeter first as your indicator. Set the bar magnet strength in the bar magnet tab to 20%. By dragging the bar magnet, position it to the left portion of the pickup coil. As it set in the left portion of the coil slowly drag the bar magnet into the coil's loop (north pole of the bar magnet must be facing the pickup coil). Observe what happens to the voltmeter dial, the electron in the loop and the magnetic field inside the loop as you drag the magnet. Observe the direction of the electron's motion, the magnetic field inside the loop and the voltage when the bar magnet approaches and leaves the loop: With the same set up, drag the bar magnet through the coil but this time at a faster speed. What happens to the value and movement of the voltmeter dial? Is it the same as the previous set up observation? Is the value larger or smaller