#include $"$msp$.$h$"$

void main$($void$)\{$

$//$ Stop watchdog timer

WDT$\_$A$->$CTL $=$ WDT$\_$A$\_$CTL$\_$PW $|$ WDT$\_$A$\_$CTL$\_$HOLD;

$//$ Configure P$1\mathrm{.}6$ as input for the switch

P$1->$DIR &$=$ ~BIT$6$; $//$ Set P$1\mathrm{.}6$ as input

P$1->$REN $|=$ BIT$6$; $//$ Enable pull$-$up$/$pull$-$down resistor for P$1\mathrm{.}6$

P$1->$OUT $|=$ BIT$6$; $//$ Set pull$-$up resistor for P$1\mathrm{.}6$

$//$ Configure P$3\mathrm{.}3$ as output for the LED

P$3->$DIR $|=$ BIT$3$; $//$ Set P$3\mathrm{.}3$ as output

P$3->$OUT &$=$ ~BIT$3$; $//$ Initially turn off the LED

$//$ Main loop

while $(1)\{$

$//$ Check if the switch is pressed

if $(!($P$1->$IN & BIT$6))\{//$ If the switch is pressed $($active low$)$

$//$ Toggle LED state every one second

P$3->$OUT $^=$ BIT$3$; $//$ Toggle LED state

$\_\_$delay$\_$cycles$(3000000)$; $//$ Delay for approximately one second

$\}$ else $\{$

$//$ If the switch is not pressed, turn off the LED

P$3->$OUT &$=$ ~BIT$3$; $//$ Turn off the LED

$\}$

$\}$

$\}$ MAKE A DIAGRAM OF THIS CODE FROM CODE COMPOSER FROM THE MSP$432$