Question: Induction motor running at asynchronous speed the torque will be a . low b . High c . 0

Induction motor running at asynchronous speed the torque will be
a. low
b. High
c.0

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Question 1: The flux per pole in a synchronous motor with the field circuit ON and the startor disconnected from the supply is found to be 25 mWb. When startor is connected to the rated supply with...

Q:

1. What would the bin width be for a spectrum using a 48,000 CPM Fmax, 1600 Lines of Resolution and a Hanning window? A) 0.75 Hz B) 3 Hz C) 45 Hz D) 0.5 Hz 2. If a PeakVue spectrum for a 1200 RPM...

Q:

6 . 1 A 3 , four pole , 5 0 Hz Induction Motor ( I . M . ) runs at 1 4 6 0 rpm Find its percentage slip. 6 . 2 A two pole , 5 0 Hz induction motor runs at 2 8 9 0 rpm . Calculate ( i ) Synchronous...

Q:

EE 3 3 0 - Electromechanical Energy Conversion ( I ) Test no . 3 / Time: 1 . 2 hr 1 s t Semester 1 4 4 5 H 1 1 9 8 Ouestion 1 ( a ) Can a 3 induction motor run at synchronous speed? Explain? ( b ) A...

Q:

( a ) The nameplate on a 3 5 0 V , 6 0 Hz , 4 pole induction motor indicates its rated speed at rated load is 1 7 5 2 rpm . When operating at rated load, determine ( i ) the angular velocity of the...

Q:

The chart below shows the starting torque for an induction motor (green curve) and the required torque to spin its load (red curve), both plotted against RPM? Match each description below with the...

Q:

With reference to a three - phase cage rotor induction motor: ( a ) explain why the rotor power factor is very low at start; ( b ) explain why the rotor core losses are negligible when the motor is...

Q:

In Fig Q3, a D.C. shunt motor takes an armature current laj of 30A from a 500V D.C. Q3 supply. It runs at N1 = 1500 rev/min. Its total armature resistance Raj is 0.22. The motor speed is decreased by...

Q:

Q.28- A DC shunt motor is running at 1200 rpm, when exited with 220 V DC. Neglecting the losses and saturation, the speed of the motor when connected to a 175 V DC supply is- (a) 750 RPM (b) 900 RPM...

Q:

An independently excited DC electric motor running at a speed of 5000 vg/min without load is supplied with a 115 V power source as shown in Figure 2. The motor runs at a speed of 1500 vg/min at a...

Q:

Cooled air is flowing through a long sheet metal air conditioning duct, 0.2 m high and 0.3 m wide. If the duct temperature is 10?C and passes through a crawl space under a house at 30?C, estimate(a)...

Q:

Currently, Chester's leverage ratio is 1.82. Next round, Chester wants to ensure it gets full balance scorecard points for leverage by increasing its leverage ratio to 2.0. The company also needs to...

Q:

Question 1 5 of 1 5 . Felipe ( 5 9 ) contributed to an HSA before he retired and still has funds available. If he uses $ 2 , 4 0 0 of his HSA flunds to pay for Marketplace insurance premiums, what is...

Q:

EX. 9??3Internal service funds are accounted for similar to businesses.William County opted to account for its duplication servicecenter in an internal service fund. Previously the center had been 2...