Question: Power supplies for telecommunications applications may require high currents at low voltages. Design a buck converter that has an input voltage of 3.3 V

Power supplies for telecommunications applications may require high currents at low voltages.

Power supplies for telecommunications applications may require high currents at low voltages. Design a buck converter that has an input voltage of 3.3 V and an output voltage of 1.2 V. The output current is 6 A and the output voltage ripple must not exceed 2 percent for 500 kHz switching frequency. Determine the inductor value such that the peak-to-peak variation in inductor current does not exceed 40 percent of the average value. Determine the capacitor value required for the ripple specification given above.

Step by Step Solution

★★★★★

3.52 Rating (165 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

An input voltage of 2 V rms (measured from base to ground) is applied to the circuit of Fig. 3.21. Assuming that the emitter voltage follows the base voltage exactly and that Vbe (rms) = 0.1 V,...

The Buck Converter has the following parameters ip Vin DA C= R Switching frequency: f, = 50 kHz; Carrie peak voltage: V 5V %3D Input Voltage: V = 20 V in Output Voltage: V = 10 V Output Current: I =5...

A simple capacitor filter has an input of 40 V dc. If this voltage is fed through an RC filter section (R = 50(, C = 40 (F), what is the load current for a load resistance of 500(?

The following sales and cost data (000s) are for two companies in the transportation industry: Required: 1. Calculate the degree of operating leverage (DOL) for each company. If sales increase from...

(a) Find parametric equations for the ellipse x2/a2 + y2/b2 = 1. (b) Use these parametric equations to graph the ellipse when a = 3 and b = 1, 2, 4, and 8. (c) How does the shape of the ellipse...

A power system for space applications is based on a Rankine cycle using potassium as the working fluid. The working fluid at the turbine inlet is at 1200 K and 2.0 bar, and is fixed. The pump inlet...

?1. A customer had sophisticated electronic equipment that kept "tripping out" causing down time and loss of money. The customer contacted you for advice to solve the problem. You installed a power...

Determine the value for c and the covariance and correlation for the joint probability mass function fXY (x, y) = c(x + y) for x = 1, 2, 3 and y = 1, 2, 3.

In Section 5.5, the one-term approximation to the series solution for the temperature distribution was developed for a plane wan of thickness 2L that is initially at a uniform temperature and...

The inventory of Wood4Fun and data on purchases and sales for a two-month period follow. The company closes its books at the end of each month. It uses the periodic inventory system. Required 1....

(a) Calculate the moment of the 90 N force about point O for the condition = 15 Also, determine the value of 0 for which the moment about O is (b) zero and (c) a maximum. 0 F = 90 N 800 mm 600 mm

A cylindrical tank with hemispherical heads is constructed of steel sections that are welded circumferentially (see figure). The tank diameter is 1.25 m, the wall thickness is 22 mm, and the internal...

Find the derivatives of the following functions. ( 2 x 3 - 8 x 2 7 } g ' ( x ) = f ' ( x ) =

The mean water temperature downstream from a power plant cooling tower discharge pipe should be no more than 100F. Past experience has indicated that the standard deviation of temperature is 2F. The...

The compressive strength of concrete is being tested by a civil engineer. He tests 12 specimens and obtains the following data. (a) Is there evidence to support the assumption that compressive...

The breaking strength of yarn used in manufacturing drapery material is required to be at least 100 psi. Past experience has indicated that breaking strength is normally distributed and that = 2 psi....

The space truss is supported by a ball-and-socket joint at D and short links at C and E. Determine the force in each member and state if the members are in tension or compression. Given: F1 = (200...

If you were starting a business, what tax considerations might cause you to prefer to set it up as a proprietorship or a partnership rather than as a corporation?

What is a way to protect ourselves and avoid electrical risks while troubleshooting a valve? (select all that apply) Question 14Answer A. Stand right underneath power lines B. Lockout Tagout C. Use...

Apple Computer had clearly established itself as the product leader in its industry by being the first company to market a complete personal computer in 1976. But by 1992, the industry had evolved in...

CASE 6.1 Advantage Energy Technology Data Center Migration * Part A Brian Smith, network administrator at Advanced Energy Technology (AET), has been given the responsibility of implementing the...

Part A Brian Smith, network administrator at Advanced Energy Technology (AET), has been given the responsibility of implementing the migration of a large data center to a new office location. Careful...

Brian Smith, network administrator at Advanced Energy Technology (AET), was given the responsibility of implementing the migration of a large data center to a new office location. Careful planning...

Brian Smith, network administrator at Advanced Energy Technology (AET), has been given the responsibility of implementing the migration of a large datacenter to a new office location. Careful...