INSTRUCTIONS: Closed Figure. A polygon is started at point A and terminates back at point $A.$ The length of each side is given in the table below. The INTERIOR angle between each side and the previous side is also given in the table. Use this information to complete the polygon. $($HINT: find the angle measured from the horizontal that will produce the specified INTERIOR angle; then use polar coordinates to draw the line.$)$ Label the points on the outside of the figure $(A,B,C,$dots$)$ using DTEXT. After the last line has been drawn, use the FILLET Command with the radius set to zero to join the lines GH and HA$.$ Note that the location of point $H$ is unknown prior to this step. Also note that line AS is given on the plate at the correct length and interior angle.

$\backslash$table$[[$Side$,$Length $($in$.),$Interior Angle,Angle$($deg$)],[$AB$,1\mathrm{.}5,$A$,60],[$BC$,0\mathrm{.}75,$B$,240],[$CD$,0\mathrm{.}5,$C$,150],[$DE$,3\mathrm{.}0,$D$,105],[$EF$,1\mathrm{.}25,$E$,55],[$FG$,2\mathrm{.}0,$F$,250],[$GH$,???,$G$,55],[$HA$,???,$H$,???$