Instructions This assignment has two parts. Both parts will be combined and submitted within the same document. For this assignment, begin by analyzing the items in the table below and then answering the associated questions Hazard Occupational Exposure Limits (OEL) Manganese Fume 5 mg/m (OSHA Ceiling) 0.1 mg/m (ACGIH 8-hour TWA (1) 0.1 mg/m (OSHA 8-hour TWA) Copper Fume 0.2 mgim (ACGIH 8-hour TWA) 0.05 mg/m (OSHA 8-hour TWA) Lead Fume 0.05 mg/m (ACGIH 8-hour TWA 1.2.4 trimethylbenzene OSHA- None Established 25 ppm (ACGIH 8-hour TWA TLV) 200 ppm (OSHA 8-hour TWA) Toluene 300 ppm (OSHA Ceiling) 20 ppm (ACGIH 8-hour TWA TLV) 100 ppm (OSHA 8-hour TWA) Xylene 100 ppm (ACGIH 8-hour TWA OSHA-None Established Metal Working Fluids 0.5 mg/m (NIOSH 10-hour TWA REL) Part 1: For each of the chemical hazards answer the following: . Compare your calculated exposures in Unit IV to one of the occupational exposure limits (OELS) in the table. . Does the calculated exposure exceed the OEL you chose? Discuss why you chose the OELs you used. Provide your opinion as to whether the risk associated with each exposure is an acceptable level of risk. Part I: Analyze the table below, and then answer the associated questions. Location Shift Length Result Shipping/Receiving 8 hours 78,3 dBA (Lavg) Hydraulic Press 12 hours 93.0 dBA (Lavg) Metal Working Line 12 hours 84 dBA (Lavg) Robotic Welding 12 hours 80.5 dBA (Lavg) Hand Welding 12 hours 81.3 dBA (Lavg) Paint Booth 12 hours 79,5 dBA (Lavg QA/QC Laboratory 8 hours 70.0 dBA (Lavg Final Inspection 8 hours 73.5 dBA (Lavg) Answer each of the following: Which of the results exceed the OSHA PEL? . Which of the result ABAPAAAM