interpreting Engineering Drawings $/$r$/$n QUESTIONS: $1.$ At what angle is the offset arm to the body of the plece? $2.$ What is the center$-$to$-$center measurement of the length of the offset arm? $3.$ Which radius forms the upper end of the oflset arm? $4.$ Which radil form the lower end of the offset arm where it joins the body? $5.$ What is the width of the bolt slot in the body of the bracket? $6.$ What is the center$-$to$-$center length of this slot? $7.$ What was the slot width before revision? $8.$ Which radil forms the ends of the pad? $9.$ What is the overall length of this pad? $10.$ What is the overall width of this pad? $11.$ What is the radili of the fillet between the pad and the body? $12.$ What is the dlameter of the shaft carrier body? $13.$ What is the diameter of the shaft camier hole? $14.$ What is the distance from the face of the shaft carrier to the face of the pad? $15.$ What is the radili of the inside fillet between the arm and the body of the piece? $16.$ If M$12$ bolts are used in hoiding the bracket to the machine base, what is the clearance on each side of the slot? $17.$ If the center$-$to$-$center distance of the two M$12$ bolts which fit the slot is $38$mm$,$ how much play is there lengthwise in the slot? $18.$ What size oll hole is in the shaft carrier? $19.$ How far is the center of the oll hole from the face of the shaft carrier? $20.$ How thick is the combined body and pad? $21.$ Calculate distance $($A$),($S$)$ and $($T$).22.$ The hole in the shaft carrier was revised. What is the difference in size between the new and old hole? $23.$ How many dimensions indicate that they are not drawn to scale? $24.$ If $2$mm is allowed for each surface to be machined, what would be the overall thickness of the original casting? $25.$ How many conventional breaks are shown? $26.$ When was the last drawing revision made?