Introduction This assignment will demonstrate your ability to design and configure a Wide Area Network (WAN) using different broadband connection such as: T-carrier, E-carrier, ISDN PRI. Implement your design using Packet Tracer. Objectives: - Design must have at least FIVE (5) branches. - Connect each end Router using T1, E1 Carrier or ISDN serial connection. - Connect each end Router using Class C IP address - Each branch must have at least 100 users. Configure each LAN with Class B IP Addresses. Use the last 2-digits of your matric no. to be the Network Address. Subnet your Class B network according to the need of your entire network. - Implement using Packet Tracer simulation Task: 1. List all network resources and components such as routers, switches, servers, PC, etc. needed in your design. 2. WAN design (Logical Diagrams and Physical Diagrams) 3. IP Address mapping, ports, interfaces, bandwidth and list of protocols and other relevant technologies. 4. Simulation, Configuration and Troubleshooting 5. Report