Objective: This project is to introduce students to multiple commands. Make sure you understand the following commands: Hatching by Pick Points Hatching by Select Objects Adjusting and editing HATCH objects Procedure: Make a drawing similar to the second page. Plot the drawing as indicated and turn it in as well as saving it. FORMAT 1. Set the unit to be DECIMAL 2. Set the LIMITS to be 30, 20 (leave the lower left corner limits to be 0,0), turn on the grid to see the limits. Then Zoom ->All 3. Create the following layers Name Color Linetype Lineweight Text Blue Continuous .15 Hatch Magenta Continuous .20 Objects Green Continuous Default Dim Red Continuous Default Use these layers while drawing. Draw the objects and HATCH as shown. Approximate sizes of the objects: Squares 4 units across. Cirlces 3 unit diameter or 1.5 unit radius. Triangle 3 sided polygon inscribed in a 1 unit Radius circle. Text inside the Triangle adjusted for your name or initials to fit. Approximately .3 units high. Be sure to change layers as needed