Place the missing words to complete the following statement about removing and replacing a U- joint using the following words. Fill in the Gaps : Drag and drop the value into text area. ringssocketretainingspiderlargepushtrunnionpressearjointCarefullyPositionshaftindexyokebrassdrivebearingassemblyStart correct 1 Clamp the slip in a vise and support the outer end of the drive shaft. 2 Remove the lock rings on the tops of the bearing cups. Make marks in the yoke so that the joint can be assembled with the phasing. 3 Select a socket that has an inside diameter enough for the bearing cup to fit into; usually a 1-inch socket works. 4 Select a second that can slide into the shaft's bearing cup bore - usually a 9/16-inch socket. 5 Place the large socket against one vise jaw. Position the shaft yoke so that the socket is around a bearing cup. 6 Position the other socket to the center of the cup opposite to the one in line with the large socket. 7 Carefully tighten the vise to the bearing cup out of the yoke and into the large socket. 8 Separate the joint by turning the over in the vise and driving the cross and remaining bearing cup down through the yoke with a drift and hammer. 9 Use a drift and hammer to drive the out of the other yokes. 10 Clean any dirt from the yoke and the ring grooves. 11 remove the bearing cups from the new U-joint. 12 Place the new inside the yoke and push it to one side. 13 Start one cup into the yoke's ear and over the cross's . 14 Carefull