Please ensure that you are using Packet Tracer 7.3.1

You are required to build an enterprise wireless access network using a Switch, Router, lightweight Access Point and a Wireless LAN Controller. In addition, you want to experiment with remote management of a wireless Home Router from a Management LAN configuration console. The network must include the following design components: [15 marks]

1. Wireless Network Access with 2 enterprise SSIDs a. One SSID connects client stations to 192.168.10.0/24 subnet, b. One SSID connects client stations to 192.168.20.0/24 subnet.

2. SSIDs require WPA2 authentication with userid and password.

3. One device providing DHCP addresses to the wireless clients.

4. At least one client connected to each SSID.

5. Access Points are connected to 10.0.10.0/24 subnet.

6. Management LAN separated from the APs by a Layer 3 router a. Management LAN devices are connected on 10.0.20.0/24 subnet.

7. Wireless LAN Controller is connected to 10.0.20.0/24 subnet.

8. Router that connects all subnets into one Layer 3 enterprise network.

9. Home router with the Internet port connected to 10.0.20.0/24 subnet.

10.Configuration console connected to 10.0.20.0/24 subnet with browser access to Home router.

11.Home router beacon is advertising SSID "Test".

12.The SSID "Test" uses WPA2 PSK authentication. Test your network

13.Wireless client associated with enterprise SSID a. Access to 192.168.10.1, b. Access to 192.168.20.1.

14.Wireless client associated with the second enterprise SSID and IP access to 192.168.20.1. 15.Wireless test client associated with Test SSID and IP access to 10.0.20.1. Documentation

1. Label the subnets, Access Switch, Router, lightweight Access Point, Wireless LAN Controller and any other computers or devices that you may have used. [5 marks]

2. Assuming that you have to explain this wireless setup to a Network Technician, write 5 steps you would like them to take to build this design. Each step should be 1 or 2 lines. Include the write-up in a text box on your Packet Tracer workspace. [5 marks] Remember to "write mem" your CLI configurations and save your workspace.