please finish the task

Task 2 (30 points) The main contents are as follows: (1) Install packet tracer. In packet tracer simulation environment, you need to be familiar with the switch command and the switch initialization configuration; (2) Implementation of VLAN configuration on switches; Requirements: Create three VLANs, give topology, view VLAN information (3) Log in to configure router based on Console console and learn related commands of router configuration. (4) Build a network environment based on packet tracer, then perform the static routing configuration and the dynamic routing configuration based on RIP respectively. Requirements: There are at least four routers in the static routing configuration topology, and there are two paths of different hop count between the source station and destination station in the RIP dynamic routing configuration, and see which path is selected after the RIP configuration. The corresponding steps are required to write, give screenshots and text description. * switch and router basic configuration command line screenshot is correct. (4 points) VLAN mainly depends on its topology and configuration screenshots or command line screenshots are correct. (8 points) Static routing configuration mainly depends on whether its router routing table configuration is correct. (10 points) IP routing mainly depends on whether each router routing table is configured correctly and whether the route is selected correctly after routing tracking. (8points)