Question: please get values for 10-16 please D. From your averaged values, please record the following: T=68FP=14.7PSI Atmospheric Pressure 14.7 Psi Initial Boiler Fill Amount 6000ml




D. From your averaged values, please record the following: T=68FP=14.7PSI Atmospheric Pressure 14.7 Psi Initial Boiler Fill Amount 6000ml Fuel Flow 5.1 Boiler Pressure 1.1E+02 Turbine Inlet Temperature 1.1F+02 Turbine Outlet Pressure 2 Turbine Outlet Temperature 9.7E+01 Steady State Condensate Amount 200mC Steady State Boiler Water Use 1000ml System Analysis Procedure: Analyze each component listed and perform the calculation requested. Gather necessary state information needed to perform calculations from steam tables. Notes: Recall that system has no condensate return pump. For analysis, assume a steady state, steady flow condition based upon the average values from the data. This is a simplification since the boiler is not equipped to receive a steady flow of condensate plus boiler makeup water during its operation. 10. Boiler (SSSF) Calculate heat flow out of boiler. Assume: No condensate pumped back into boiler, Changes in Kinetic and Potential Energy are negligible. Q8+min(hin+KEin+PEin)=mout(hout+KEout+PEout+out)nopumpB=mouthout{m=qwatereweter} 11. Boiler (SSSF) How does the calculated heat flow out of the boiler above compare with the measured LP gas flow to burner? 2520ft38bsor93756KgkJ erow rate
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
