Please help. I'm not sure how to implement an interrupt. Any way to show me how would surely help.

You need to devise a scheme tocontrol a set of LEDs connected to GPIO pins of the PSoC-5 microcontroller. The software contr the states of the LEDs by writing into a variable LEDstate, ols declared as an unsigned 8-bi tintegerinthe program. uint8 LED state The value assigned to it must be reflected onthe LEDs. For example, the assignment LEDstate Oxff should cause all the LEDs to be ON, and the assignment LED state 0; should turn all of them off. You can also make them blink at 1-second intervals using the code segment while (1) LED state xff Cy delay (500); LED state 0; Cy delay (500) Your task isto make thevalue assigned to LEDstatereflect on the pins. This does not need to be instantaneous. Itis acceptable to have a small delay (less than 1ms for the valueto be reflected on the LEDs. Explain how you can make the value assigned to the variable te reflecton the pins using interrupts. Youmay use other components such as timers, counters, control and status registers, etc. Describe with a block diagram ofthe components and its operation. You don't nee to provide the schematics orCcode from PSoccreator You need to devise a scheme tocontrol a set of LEDs connected to GPIO pins of the PSoC-5 microcontroller. The software contr the states of the LEDs by writing into a variable LEDstate, ols declared as an unsigned 8-bi tintegerinthe program. uint8 LED state The value assigned to it must be reflected onthe LEDs. For example, the assignment LEDstate Oxff should cause all the LEDs to be ON, and the assignment LED state 0; should turn all of them off. You can also make them blink at 1-second intervals using the code segment while (1) LED state xff Cy delay (500); LED state 0; Cy delay (500) Your task isto make thevalue assigned to LEDstatereflect on the pins. This does not need to be instantaneous. Itis acceptable to have a small delay (less than 1ms for the valueto be reflected on the LEDs. Explain how you can make the value assigned to the variable te reflecton the pins using interrupts. Youmay use other components such as timers, counters, control and status registers, etc. Describe with a block diagram ofthe components and its operation. You don't nee to provide the schematics orCcode from PSoccreator