please help me out with part D. the answe is not 2.935 m that was wrong

In your job in a police lab, you must design an Part C apparatus to measure the muzzle velocities of bullets fired from handguns. Your solution is to attach a 2.00 kg wood block that rests on a You want the maximum compression of the spring to be 0.24 m. What must be the force constant of the spring? horizontal surface to a light horizontal spring. The other end of the spring is attached to a wall. Initially Express your answer with the appropriate units. the spring is at its equilibrium length. A bullet is fired horizontally into the block and remains embedded in k = 78 N it. After the bullet strikes the blook, the block compresses the spring a maximum distance d. You have measured that the coefficient of kinetic friction Previous Answers between the block and the horizontal surface is 0.38. The table below lists some firearms that you will test. A grain is a unit of mass equal to 64.80 mg. Correct Bullet Muzzle Bullet Type Mass Velocity (grains) (ft/s) Part D 38Spec Glaser 1667 Blue For the bullet that produces the minimum spring compression, what is the compression d if the spring has the force constant 38 Spec 125 945 calculated in part C? Federal Express your answer with the appropriate units. 44Spec 240 851 Remington 44Spec O 200 819 HA Winchester 45ACP Glaser 1355 LLI 140 Blue d = Value Units Submit Previous Answers Request