Question: Please note that i only need help with Number 4 i am posting previous questions since they are all connected together I have bolded the
Please note that i only need help with Number 4 i am posting previous questions since they are all connected together I have bolded the question at the bottom.
Using Cisco packet tracer construct the network shown in figure below. A crossover data cable is used to connect each of the host computers H1, H2 and H3 to each of routers R1, R2 and R3, respectively. A WAN serial link is used to connect routers R1 and R2 and another WAN serial link is used to connect routers R2 and R3. Three console cables are also used in the network to enable configuring routers R1, R2 and R3 from the respective host computers H1, H2 and H3.
1.Perform basic configuration for each router including the host name and the IPv4 addresses of their network interfaces.
2.Configure the NIC interface of each host computer including the IPv4 address, mask and default gateway.
3.Verify connectivity from each host computer to its default gateway. Is pinging successful?
Answer: no
Also from each host computer ping the other directly connected interfaces of their default gateway routers. Is pinging successful?
Answer: no
4.Verify connectivity from each host computer to the other two host computers. Is pinging successful?
Answer: no
If the answer is NO as expected, then explain why:
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
