Please show me$,$ on Logicly, the circuits that I should make for this voting machine to replace "selections ccts$"$ and the three "decade counter":

Design a voting machine using the logic simulator Logicly. It should offer the voter a choice of three candidates and be able to register up to $99$votes for each candidate. The count should be displayed as a decimal number, using two $7-$segment displays for each candidate. Polling is to be $$private$,$but supervised by a human operator. The machine should be designed to run like this:

$1.$When the simulation is started, the supervisor pushes a button $($Reset$)$to clear all counters.

$2.$The supervisor then pushes a button $($Ready$)$to enable the machine to record a vote.

$3.$The voter chooses a candidate by pushing one of three buttons. LEDs associated with each button indicate the selection. The voter can change their selection any number of times. The vote will not be recorded until the next step.

$4.$The voter pushes a separate button $($Cast vote$)$to cast the vote. An LED indicates that a vote has been accepted. The machine should not accept any changes after this, nor allow multiple votes by the same voter. If the voter pushes the $$Cast vote$$button before making a candidate selection, the machine should ignore it and allow the voter to continue with candidate selection and casting as usual.

$5.$After the vote is cast, the supervisor again pushes the $$Ready$$button$,$ enabling the machine to accept the next vote. Pushing the $$Ready$$button should clear all the LEDs so that the next voter does not see the choice just recorded

$-$implementation notes

$*$Only momentary pushbuttons are allowed $-$no toggle switches. See the Logicly schematic on the next page. $($You do not have to place your circuitry in boxes as shown in the schematic $-$this was done just to hide the contents from you for this test!$)$

$*$PLEASE put the pushbuttons, LEDs, and $7-$segment displays in one easy$-$to$-$find area of your schematic. We have more than $100$machines to grade, and at $5$minutes each, this is more than $8$hours of grading. If we can$$t find your controls and indicators immediately, you will lose points!

$*$The machine contains memory elements, and these must be initialized. You may specify a startup procedure. Describe it in a text field placed on your schematic. At the very least, when you open the Logicly file you will have to reset the simulation and then play it

Thank you in advance!