Question: Please solve it by computer don't by hand 3. 2.5 kg of gas at initial state of 0.7 m' and 15C. It is heated at

Please solve it by computer don't by hand

3. 2.5 kg of gas at initial state of 0.7 m' and 15C. It is heated at constant volume until its temperature became 135C. Determine (3 Marks) a. The heat transfer from or to the gas. b. The final pressure. c. The work done by or to the gas. Take R =0.29 kJ/kg, Cp= 1.005 kJ/kg.K

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

kindly answer all these A space probe, initially at rest, undergoes an internal mechanical malfunction and breaks into three pieces. One piece of mass m 1 5 48.0 kg travels in the positive x -...

3-1C W hat is the difference between saturated liquid and compressed liquid? 3-2C What is the difference between saturated vapor and superheated vapor? 3-3C Is there any difference between the...

ANSWER ALL QUESTIONS. 3-68 A 0.3-m3 rigid vessel initially contains saturated liquid-vapor mixture of water at 150C. The water is now heated until it reaches the critical state. Determine the mass of...

Republic of Iraq Ministry of Higher Education and Scientific Research University of Technology Chemical Engineering Department MODELING AND SIMULATION OF FCC RISERS A RESEARCH SUBMITTED TO THE...

1. How many kcal of heat are required to heat 12kg of Glass from 15C to 325C? [3 Marks] 2. How many joules of heat are given off when 50kg of Aluminum cools from 245C to 25C? [3 Marks] 3. Determine...

Chapter 14 All about Heat and Work In This Chapter Understanding the laws of thermodynamics Working with isobaric processes Handling isochoric processes Calculating isothermal processes his chapter...

Question 1 A steam power cycle with regeneration as shown below on the T-s diagram employs a single open feedwater heater for efficiency improvement. The fluids mix with each other in an open...

5-180 Determine the power input for a compressor that compresses helium from 150 kPa and 20C to 400 kPa and 200C. Helium enters this compressor through a 0.1-m2 pipe at a velocity of 15 m/s. 5-181...

ATTEMPT ALL QUESTIONS. BE SURE TO ANSWER A body with mass m = 1 2 kg is attached to the end of a spring that is stretched 2 m by a force of 100 N. Furthermore, there is also attached a dashpot4 that...

A cylinder made of copper with a mass of 0.80 kg is heated to 800C, then dropped into 6.00 kg of water at 11C. What is the total change in entropy (in J/K) of the cylinder-water system, assuming no...

A circular bar of magnesium alloy is 750 mm long. The stressstrain diagram for the material is shown in the figure. The bar is loaded in tension to an elongation of 6.0 mm, and then the load is...

A flow of 1 kg/s carbon dioxide at 1600 H, 100 kPa is mixed with a flow of 2 kg/s water at 800 H, 100 kPa and after the mixing it goes through a heat exchanger where it is cooled to 500 H by a 400 H...

( e ) Mexican investors buy $ 1 0 million worth of 3 0 - year U . S . Treasury bonds. answer is No change in any accounts in either country

Which of these statements about Active Directory ( AD ) are true? ( Choose all that apply ) AD can "speak" LDAP. A D includes a tool called the Active Directory Authentication Center, or ADAC. A D is...

1. Both antitrust policy and industrial regulation deal with monopoly. What distinguishes the two approaches? How does government decide to use one form of remedy rather than the other? LO21.1, LO21.3

2. Describe the major provisions of the Sherman and Clayton acts. What government entities are responsible for enforcing those laws? Are firms permitted to initiate antitrust suits on their own...

LO21.2 Describe some of the key issues relating to the interpretation and application of antitrust laws.