Question: Please write it in a typing form and not hand written, thank you! Question: Write an AVR program that read the potentiometer voltage measurements as

Please write it in a typing form and not hand written, thank you!
Question: Write an AVR program that read the potentiometer voltage measurements as analog data through channel 0 of ADC. ADC uses 5V AVCC as Vref, right-justified the result, and a prescaler of 128. Program the microcontroller to automatically finish the conversion from analog to binary and save the binary result in an integer variable. If the measured voltage is above 10000000002, then the LED attached to pin PBO will turn on. When on turning of the potentiometer, the voltage goes below 2.5V, then the LED will shut off
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
