Prepare an appropriate flowchart for this Arduino Uno code:

void setup() { // put your setup code here, to run once: Serial.begin(9600); }

void loop() { // put your main code here, to run repeatedly: float val1 = analogRead(A3); //declare which pin is use as input for first reading delay(300); //delay to differentiate the value between first and second reading float val2= analogRead(A3); //declare which pin is use as input for second reading float difval = val2 - val1; //the difference of reading when pressure is applied Serial.println(difval); //show the input in serial monitor

if (-10050) { delay(500); } }