Problem 1: Consider the following cam design CEP specification: dwell rise dwell fall carn at zero displacement for 80 degrees (low dwell) 10 mm in 100 degrees at 10 mm for S0 degrees (high dwell) 10 mm in 100 degrees 20 rad/s Create the SVAJplots for the rise segment only (use Excel or MATLAB) and use it to find the peak velocity (mm/s) and acceleration (mm/s2) for each case of parameters given below (note: refer to Table 8-2 for guidance). Specify the acceptable SCCA family of functions respective to each case. a) b 0.15,c 0 b) b 0.15, d 0.15 Problem 1: Consider the following cam design CEP specification: dwell rise dwell fall carn at zero displacement for 80 degrees (low dwell) 10 mm in 100 degrees at 10 mm for S0 degrees (high dwell) 10 mm in 100 degrees 20 rad/s Create the SVAJplots for the rise segment only (use Excel or MATLAB) and use it to find the peak velocity (mm/s) and acceleration (mm/s2) for each case of parameters given below (note: refer to Table 8-2 for guidance). Specify the acceptable SCCA family of functions respective to each case. a) b 0.15,c 0 b) b 0.15, d 0.15