Problem \#2 (25 points) MSP430 Addressing Modes, Instruction Encoding Consider the following instructions given in the table below. For each instruction determine its length (in words), the instruction words (in hexadecimal), source operand addressing mode, and the content of register R7 after execution of each instruction. Fill in the empty cells in the table. The initial content of memory is given below. Initial value of registers R5, R6, and R7 is as follows: R5=0xFO02, R6=0xF00A, R7=0xFF88. Assume the starting conditions are the same for each question (i.e., always start from initial conditions in memory) and given register values. The format of the first word of double-operand instructions is shown below. (Note: Op-code for MOV is 0100)