Problem 5-39 Resource and Activity-Based Cost Drivers [LO 5-1, 5-3] EyeGuard Equipment Inc. (EEI) manufactures protective eyewear for use in commercial and home applications. The product is also used by hunters, home woodworking hobbyists, and in other applications. The firm has two main product lines-the highest-quality product is called Safe-T, and a low-cost, value version is called Safe-V. Information on the factory conversion costs for EEI is as follows: Salaries Supplies Factory expense Factory Costs $ 853,000 153,000 553,000 $1,559,000 EEl uses ABC to determine the unit costs of its products. The firm uses resource consumption cost drivers based on rough estimates of the amount that each activity consumes, as shown below. EEl has four activities: job setup, assembly, inspecting and finishing, and packaging. Setup 20% 25 Assembly 60% Inspecting and finishing 157 Packaging 5% Salaries Supplies Factory expense Total 100% 100 100 15 90 10 The activity cost drivers for the two products are summarized below. Activities Setup Assembly Inspect and finishing Packaging Activity Driver Batch Units Finishing hours Packing hours Batches Units Finishing hours, per unit Packaging hours, per unit Materials per unit Safe-V 280 63,000 0.30 0.20 $ 4.00 Safe-T 630 75,000 0.20 0.10 $ 5 Required: 1. Determine the amount of the cost pool for each of the four activities. 2. Determine the activity-driver rates for assigning factory costs to the two products. 3. Determine the activity-based unit cost for each of the products. Complete this question by entering your answers in the tabs below. Required 1 Required 2 Required 3 Determine the amount of the cost pool for each of the four activities. Inspecting & Factory Costs Setup Assembly Packaging Finishing Salaries Supplies Factory expense 0 $ Required 1 Required 2 Required 3 Determine the activity-driver rates for assigning factory costs to the two products. (Round your answers to 2 decimal places.) Activity-Driver Rates Setup Assembly Inspect and Finish Packaging Required 1 Required 2 Required 3 Determine the activity-based unit cost for each of the products. (Round your intermediate calculations and final answers to 2 decimal places.) Safe-V Safe-T Activity-based cost per unit