Question: Procedure 1 : Setup and Measurement of Initial Evacuation Time 1 . Connect the roughing pump to the vacuum chamber. 2 . Close the chamber
Procedure : Setup and Measurement of Initial Evacuation Time
Connect the roughing pump to the vacuum chamber.
Close the chamber and ensure all seals are secure
Turn on the roughing pump and start the stopwatch.
Observe the vacuum gauge. Note the time it takes for the pressure to reach the desired level. This is your initial evacuation time.
Record your observations.
Procedure : Introduction of Turbo Vacuum Pump
Connect the turbo vacuum pump to the system in series with the roughing pump.
Repeat steps to Observe how the addition of the turbo pump affects the evacuation time.
Record your observations.
Step by Step Solution
There are 3 Steps involved in it
1 Expert Approved Answer
Step: 1 Unlock
Question Has Been Solved by an Expert!
Get step-by-step solutions from verified subject matter experts
Step: 2 Unlock
Step: 3 Unlock
