Project Deliverables You have one push button to drive a conveyor (DC motor) in one direction and another push button which sends the conveyor in the other direction. When you are not pushing a button, it is not moving. You will use two push buttons and a DC motor to simulate this. As an additional indicator, you will blink an LED when the motor is moving Clockwise, and it will be solid when the motor is moving Counter Clockwise. You also have a temperature control system to operate a damper. You will simulate this by driving a servo motor to 0 degrees position when room temperature is below 80F, and to 180 degrees position when the room temperature is above 90F. Between 80F and 90F, the servo motor should sit at 90 degrees. You will measure temperature with a thermistor and will display the temperature on your LCD. In addition, your push buttons should not operate the conveyor unless your temperature is between 80F and 90