Project Network Reconnaissance and Port Scanning using nmap We need to use two VMs for this project: the Kali Linux and the Metasploitable$2-$Linux. Finding the IP Address of the Target For the purpose of this project, we use Metasploitable$2-$Linux as the target. $1)$ First, we need to find the host IP address of the target to launch a scanning. You can use the command ifconfig $($ipconfig is the windows equivalent$).$ This command allows you to find all the connected interfaces and network cards. Go to the Metasploitable$2-$Linux VM$,$ and execute the following command ifconfig. Then using Kali terminal we will scan the target. Use man nmap to find more information about nmap tool. $2)$ Perform a basic nmap host discovery scan without port scanning. Normally this would be used to scan an entire subnet $($or larger$),$ but for this lab, we are going to target specific IPs of interest. $3)$ Perform a nmap TCP port scan on the Metasploitable$2$ VM to detect active services. $4)$ Perform a nmap UDP port scan on the Metasploitable$2$ VM to detect active services. $5)$ Perform a nmap OS Detection scan on the Metasploitable$2$ VM$.6)$ Perform a nmap version and service scan of the Metasploitable$2$ VM: $7)$ Perform a nmap scan against the Metasploitable$2$ VM using the $-$A $($for all$)$ option. This is the most time consuming scan $($at least for TCP$)$ and the most verbose. Note: Sent a screenshot for every task.