Read the case scenario and answer the questions listed below. Please note copy and peste using any aid in answering the questions may result in a penalty including a zero matk Case (10 martes) A worker was moving a large electrical panel, which measured 8 feet tall, 18 feet long and 18 inches wide, weighing about 4,000 lbs, intending to load it onto a truck. The panel was put on two wheeled dollies, one at the front and one at the rear of the panel However, the feet in the centre of the panel impeded movement, as the dollies were not tall enough to allow the feet to clear the floor. The worker jacked up the bottom of the panel in an attempt to install wood studs on the dollies to raise the panel higher. While doing so, the panel tipped over and fell on the worker. As the panel tipped over, it also struck another nearby worker. Both workers suffered injuries. The employer was fined $50, 000 for the incident. Read the case scenario and answer the following questions: 1) Identify the unsafe condition and the unsafe act? (2 marks) 2) What controls would you recommend on the basis of your response to Q1? (8 marks)