Refer to able 56.1 - Factors for Computing Control Chart Limits (3 siama for this problem. Twelve samples, each containing five parts, were taken from a process that produces steel rods at Emmanual Kodzi's factory. The length of each rod in the samples was determined. The results were tabulated and sample means and ranges were computed. The results were: O Sample 1 2 3 4 5 6 Sample Mean Range Sample Sample Mean (in.) Range (in.) (in.) (in.) 8.104 0.044 7 8.101 0.021 8.102 0.051 8 8.103 0.058 8.089 0.042 9 8.095 0.039 8.104 0.037 10 8.101 0.038 8.097 0.048 11 8.101 0.054 8.101 0.053 12 8.104 0.061 = For the given data, the x = inches (round your response to four decimal places). Based on the sampling done, the control limits for 3-sigmax chart are: Upper Control Limit (UCL;) - inches (round your response to four decimal places). Lower Control Limit (LCL;) - inches (round your response to four decimal places). Based on the x-chart, is one or more samples beyond the control limits? For the given data, the R= inches (round your response to four decimal places). The control limits for the 3-sigma R-chart are: Upper Control Limit (UCLR) = inches (round your response to four decimal places). Lower Control Limit (LCLR) = inches (round your response to four decimal places). Based on the R-chart, is one or more samples beyond the control limits? Definition Sample Size, n 3 NOCOU WN Mean Factor, Az 1.880 1.023 0.729 0.577 0.483 0.419 0.373 0.337 0.308 0.266 Upper Range, D 3.268 2.574 2.282 2.115 2.004 1.924 1.864 1.816 1.777 1.716 Lower Range, D 0 0 0 0 0 0.076 0.136 0.184 0.223 0.284 9 10 12 Print Done