Refer to Table 56.1. Factors for Computing Control Chart Limits.(3.sigmo) for this problem, Sampling 4 pieces of precision-cut wire to be used in computer assembly) every hour for the past 24 hours has produced the following results: X R Hour X 3.25 3.20 3 3.22 3.39 5 2.97 6 2.76 R R Hour 0.65" 7 1.188 1.389 1.21 10 3.15 2.75 3.02 2.75 2.73 0.48" 1.18 0.76 1.28 1.12 0.35 Hour 13 14 15 16 17 18 X R 3.21 0.85 2.93 1.26 3.221.01 2.94 0.45 2.76 1.43 2.84 1.24 Hour X 19 4.51" 202.79 21 2.65 22 3.18 2 3 2.94 24 2.64 R 1.56" 1.04 1.08 0.46 1.58 0.97 0.42 2.87 Based on the sampling done, the control limits for 3-sigma x chart are (round ediate calculations to three decimal places before proceeding with further calculations): Based on the sampling done, the control limits for 3-sigma x overbarx chart are (round all intermediate calculations to three decimal places before proceeding with furthercalculations): Upper Control Limit (UCL Subscript x overbarUCLx) = ? Lower Control Limit (LCL Subscript x overbarL.CLx) = ? Based on the x overbarx-chart, the wire cutting process has been IN CONTROL or OUT OF CONTROL? The control limits for the 3-sigma R-chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL Subscript Upper RUCLR) = ? Lower Control Limit (LCL Subscript Upper RLCLR) = ? Based on the R-chart, the wire cutting process has been IN CONTROL or OUT OF CONTROL