Required information Problem 17-27 Joint Costs (LO 17-4, 17-5) [The following information applies to the questions displayed below.] Snake River Sawmill manufactures two lumber products from a joint milling process. The two products developed are mine support braces (MSB) and unseasoned commercial building lumber (CBL). A standard production run incurs joint costs of $400,000 and results in 70,000 units of MSB and 100,000 units of CBL. Each MSB sells for $4, and each unit of CBL sells for $6. coblem 17-27 Part 1 quired: Calculate the amount of joint cost allocated to commercial building lumber (CBL) on a physical-units basis. (Round the calculation of elative Proportion" to the nearest whole percent. Round your final answer to the nearest dollar amount.) 2. Calculate the amount of joint cost allocated to the mine support braces (MSB) on a relative-sales value basis. (Round the calculation of "Relative Proportion" to the nearest whole percent. Round your final answer to the nearest dollar amount.) 3. Assume the commercial building lumber is not marketable at split-off but must be further planed and sized at a cost of $457,000 per production run. During this process, 11,000 units are unavoidably lost; these spoiled units have no value. The remaining units of commercial building lumber are saleable at $12 per unit. The mine support braces, although saleable immediately at the split-off point, are coated with a tarlike preservative that costs $200,000 per production run. The braces are then sold for $10.00 each. Using the netrealizable-value basis, compute the completed cost assigned to each unit of commercial building lumber. (Round the calculation of "Relative Proportion" to the nearest whole percent. Round your final answer to 2 decimal places.) 4. If Snake River Sawmill chose not to process the mine support braces beyond the split-off point, the contribution from the joint milling process would increase or decrease by what amount? 5. Which of the following statements is true? The allocation of joint costs is irrelevant to the decision about coating the mine support braces. The decision should be based entirely on information pertaining to events from the split-off point forward. The joint cost allocation results should be used in the decision about coating the mine support braces because the decision should be based on total costs, i.e., costs incurred prior to split-off as well as those incurred post split-off