Question: ? soft foot is prevented by using clean, solid bases with all paint, grime, rust, and corrosion thoroughly removed. Select one: a . Angular b

? soft foot is prevented by using clean, solid bases with all paint, grime, rust, and corrosion thoroughly removed.
Select one:
a. Angular
b. Induced
c. Parallel
d. Springing
? soft foot is prevented by using clean, solid

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

DQ 7 2 ) A motor is being installed, which pre - alignment checks are done?A . Perform rough alignment, check soft foot, inspect jacking screws, then performfinal alignment.B . Clean base, inspect...

Q:

True or False: When checking for soft foot on a large, heavy machine resting on I-beam rails, it is always advisable to use the one-foot-at-atime method called for by the laser equipment manual.

Q:

Rough handling of a machine or uneven mounting pads due to poor machining or welding often causes ? soft foot. a . angular b . induced q , c . parallel d . springing

Q:

What is an indication of soft foot? A . Pipe strain. B . Uneven surface contact. C . Offset misalignment. D . Excessive noise.

Q:

Gralyn Corp compares two products margin of safety ratios (MOS). Product A has a ratio of 13 and product has a ratio of 1 Everything else held constant wut should the managers at Gralyn Corp. do and...

Q:

What is the maximum amount of soft foot permissible?

Q:

? soft foot is a condition that exists when external forces are applied to a machine. a . Angular b . Induced c . Parallel d . Springing

Q:

WM21 After examining the work order history, a maintenance manager finds 25% of the work orders were written and executed on the same day (unscheduled); 60% were formally scheduled the day before...

Q:

Excused Performance When Circumstances Change I. Introduction Circumstances change. Contracts made in good times may have to be performed in bad times. The cost of the seller's raw materials may...

Q:

Principles of Marketing Case Study GREEN CHILLYZ: REDEFINING MARKET BOUND Write in continuous prose i.e. do not differentiate between questions while answering. Your response to this assignment...

Q:

Liquid water enters a 25-kW pump at 100-kPa pressure at a rate of 5 kg/s. Determine the highest pressure the liquid water can have at the exit of the pump. Neglect the kinetic and potential energy...

Q:

Determine the placement of departments in the following floor plan that will minimize total transportation cost using the data in the following tables. Assume that reverse distances are the same. Use...

Q:

For purposes of the generation - skipping transfer tax ( GSTT ) all of the following are considered skip persons except A ) the transferor s ex - spouse, who is 4 0 years younger than the transferor....

Q:

Required: Suppose you are a euro-based Italian investor, and you are investing 10,800 to buy shares of a British company at 50 per share. The exchange rate is 1.35 per pound. The stock pays a 1...