Solve 1.1. Use MATLAB and provide files!

PROBLEM 1.1 For different location points in a structure we have different calculated stresses. 1. Work case 4 2. Determine all the loads by hand. Then use the hand-determined-londs per section to plot them in MATLAB Note that the on the point load acting at 45 angle and torsional act at the centerline, The transverse lond acts on the edge. You will need to transfer the lond to the mid-section first (will add a distributed torque around the x-axis). Table 1: Data for Problem 1-1. 2 3 Figure P TOO 16 100D 100 ID 100 ID 10 in 10 in 10 in 100 x 10/100 (L) lb/in 100 (1/2-) 1b/in 100 lb/in Note: You will need to find the true that will be the calculated distributed tope. Take the width of the squared action 2 inchen PROBLEM 1.1 For different location points in a structure we have different calculated stresses. 1. Work case 4 2. Determine all the loads by hand. Then use the hand-determined-londs per section to plot them in MATLAB Note that the on the point load acting at 45 angle and torsional act at the centerline, The transverse lond acts on the edge. You will need to transfer the lond to the mid-section first (will add a distributed torque around the x-axis). Table 1: Data for Problem 1-1. 2 3 Figure P TOO 16 100D 100 ID 100 ID 10 in 10 in 10 in 100 x 10/100 (L) lb/in 100 (1/2-) 1b/in 100 lb/in Note: You will need to find the true that will be the calculated distributed tope. Take the width of the squared action 2 inchen