Switch SW$1$ uses its Gigabit $0/1$ interface to connect to switch SW$2$ s Gigabit $0/2$ inter$$face$.$ SW$2$ s Gi$0/2$ interface is configured with the speed $1000$ and duplex full com$$mands$.$ SW$1$ uses all defaults for interface configuration commands on its Gi$0/1$ interface. Which of the following are true about the link after it comes up$?($Choose two answers.$)$

The link works at $1000$ Mbps $(1$ Gbps$).$

SW$1$ attempts to run at $10$ Mbps because SW$2$ has effectively disabled IEEE stan$$dard autonegotiation.

The link runs at $1$ Gbps$,$ but SW$1$ uses half duplex and SW$2$ uses full duplex.

Both switches use full duplex.