Task $1$: Subnet the Address Space.

Step $1.$ Examine the network requirements.

You have been given the $192\mathrm{.}168\mathrm{.}64\mathrm{.}0/24$ address space to use in your network design. The network consists of the following segments:

$$ The Fa$0/0$ connected to router R$1$ will require enough IP addresses to support $84$ hosts.

$$ The Fa$0/1$ connected to router R$1$ will require enough IP addresses to support $82$ hosts.

Step $2.$ Assign network addresses to the Topology Diagram.

Assign the First valid host address of each subnet to the router interfaces.

Assign the next valid host address of each subnet to PC$$s$.$

Task $2$: Configure the FastEthernet Interface with the appropriate IP Addresses.

Step $1$: Configure the router interfaces.

Note: Remember the Port Status of the interface must be turned on $($no shut$).$

Step $2$: Configure the PC interfaces.

Configure the Ethernet interfaces of PC$0$ PC$1$ with the IP addresses and default gateways from your network design.

Task $3$: Verify the Configurations.

Answer the following questions to verify that the network is operating as expected.

From the PC$1$ attached to R$1,$ is it possible to ping the default gateway?

From the PC$0$ attached to R$1,$ is it possible to ping the default gateway?

Can you ping between all PC$$s$?$