Task $2$ Programming the network You will use the console cable you connected from the Router to the PC to program the Router. First, we need to connect to the Router. If you are using Packet Tracer, open the PC$,$ go to Desktop, and click on terminal. Click on the OK button. If you are using physical equipment, open a command prompt and type the command mode. This will show you the serial ports attached to the system. Note the serial port number and type putty to open the terminal program. Click on the Serial button on putty and then change the serial line to the COM port from the computer. Click on the Open button and press the enter key a couple of times to start talking to the Router.