Task 6 - Blinking LED using CTC Mode (Period of 2 seconds). Write a program that makes LED blink with a frequency of 0.5 Hz (period of 2s). Questions: Q1. For the period of 2 seconds (one second on, one second off), which timer do you have to use? Q2. What is the configuration of the timer? a. Mode b. TOP value. Keep in mind that the blinking of the LED must be very precisely a period of 2 seconds. c. COMnX value d. Prescaler Q3. What pin would you like to use to connect the LED to? Hint: You want to have the foc as 0.5 Hz (a period of 2) with felk = 16MHz foc = 0.5 Hz folk foc 2. Prescaler . (OCRnX + 1) You need to choose what Timer you want to use (Timero, Timerl or Timer2). You need to choose which Prescaler to use. You need to decide the TOP value (the OCRnX) value. You need to declare the corresponding pin as an OUTPUT to use it as OUTPUT The task has been completed successfully if the while loop is empty entirely and no delay function calls are in the program at all, while the LED blinks in a period of precisely 2 seconds. Modify the code from Task 6 and make the LED blink with a frequency of 1Hz (period of 1s). Questions: Q1. For the period of 2 seconds (one second on, one second off), which timer do you have to use? Q2. What is the configuration of the timer? a. Mode b. TOP value. Keep in mind that the blinking of the LED must be very precisely a period of 2 seconds. COMnX value d. Prescaler Q3. What pin would you like to use to connect the LED to? c