The assignments must be prepared according to the writing rules of the bachelor's degree thesis and...

Transcribed Image Text:

The assignments must be prepared according to the writing rules of the bachelor's degree thesis and delivered as a hard copy before the deadline. Deadline: 15.01.2024 (16:59) dev lisans bitirme tez yazm kurallar dikkate alnarak hazrlanmas gerekmekte olup son tarihinden nce basl olarak teslim edilmesi gerekmektedir. Son teslim tarihi: 15.01.2024 (16:59) Ad: (Name): Soyad: (Surname): Numara: (Number): mza (Sign) 1) A system is loaded as shown in the figure below. Points A and C are bearing locations. Shaft is made of a steel having Sy: 567 MPa and Sut: 676 MPa. (All dimensions are in mm, D/d is 1.1 and fillet radius are 3 mm.) a) Evaluate the total forces, moments and torques acting onto the system. b) Design the shaft based on a factor of safety of A,B for 90 percent reliability and infinite life. The shaft is machined surface. Z A 0120 B y 350N 1AB 600N 400N E 250N 0160 NOTE! State all the assumptions that you make in design process in the assignment. The assignments must be prepared according to the writing rules of the bachelor's degree thesis and delivered as a hard copy before the deadline. Deadline: 15.01.2024 (16:59) dev lisans bitirme tez yazm kurallar dikkate alnarak hazrlanmas gerekmekte olup son tarihinden nce basl olarak teslim edilmesi gerekmektedir. Son teslim tarihi: 15.01.2024 (16:59) Ad: (Name): Soyad: (Surname): Numara: (Number): mza (Sign) 1) A system is loaded as shown in the figure below. Points A and C are bearing locations. Shaft is made of a steel having Sy: 567 MPa and Sut: 676 MPa. (All dimensions are in mm, D/d is 1.1 and fillet radius are 3 mm.) a) Evaluate the total forces, moments and torques acting onto the system. b) Design the shaft based on a factor of safety of A,B for 90 percent reliability and infinite life. The shaft is machined surface. Z A 0120 B y 350N 1AB 600N 400N E 250N 0160 NOTE! State all the assumptions that you make in design process in the assignment.