Question: The following system has two loads. The first load draws an apparent power of 30 kVA with a power factor of 0.9 lagging. T

The following system has two loads. The first load draws an apparent power of 30 kVA with a power factor of 0.9 lagging. T

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Physics Questions!

Q:

The following system has two loads. The first load Z draws an apparent power of 30 kVA with a power factor of 0.9 lagging. The second load draws 40 kW of power with a power factor of 0.795 lagging....

Q:

A load draws an apparent power of 30 kVA at a power factor of 0.8 lagging from a 2400-V (rms) source. Find P, Q, and the load impedance.

Q:

1658 Two balanced three-phase loads are connected in parallel. The first load absorbs 25 kW at a lagging power factor of 0:9. The second load absorbs an apparent power of 30 kVA at a leading power...

Q:

1667 In Figure P1667, the source at bus 1 supplies two load buses through transmission lines with wire impedances of ZW1 = 6 + j33 =phase and ZW2 = 3 + j15 =phase. The load at bus 2 draws an apparent...

Q:

In Figure P16-53, the source at bus 1 supplies two load buses through transmission lines with wire impedances of \(Z_{\mathrm{W}_{1}}=6+j 33 \Omega /\) phase and \(Z_{\mathrm{W}_{2}}=3+j 15 \Omega...

Q:

In Figure P1667 the source at bus 1 supplies two load buses through transmission lines with wire impedances of ZW1 6 j33 V=phase and ZW2 3 j15 V=phase. The load at bus 2 draws an apparent power 4...

Q:

For the network shown in the following figure, the two loads can be described as follows: Load absorbs an average power of 2 4 . 9 6 kW at a lagging power factor of 0 . 4 6 8 7 Load 2 has an...

Q:

Calculate the capacitance of a condenser to be connected in series with 100-V 80-W lamp to enable it to be used on 200-V, 50 Hz supply. At what frequency will the inductive reactance of a 0.0211-H...

Q:

Two balanced three-phase loads are connected in parallel. The first load absorbs \(25 \mathrm{~kW}\) at a lagging power factor of 0.9. The second load absorbs an apparent power of \(30 \mathrm{kVA}\)...

Q:

For the network shown in the following figure, the two loads can be described as follows: Load 1 absorbs an average power of 2 4 . 9 6 kW at a lagging power factor of 0 . 4 6 8 7 . Load 2 has an...

Q:

Given the probability distributions for variables X and Y shown to the right, compute the terms below. a. E(X) and E(Y) a. E(X)= E(Y)= b. ox Oy (Type an integer or a decimal.) (Type an integer or a...

Q:

An electron in a cathode ray tube (CRT) accelerates from 2.00 x 104 m/s to 6.00 x 106 m/s over 1.50 cm. (a) How long does the electron take to travel this 1.50 cm? (b) What is its acceleration?

Q:

7 Multiple Choice 1 . 6 6 7 points If a project with conventional cash flows has a profitability index of 1 . 0 , the project will: have a negative internal rate of return. have an internal rate of...

Q:

Question 4 (5 marks) The cleaning department of Andalusia Hospital uses a 2-week weighted moving average to predict the use of hygiene equipment in the main hospital building. The following table is...

Q:

5. How can a sender (utterer) directly influence the interpreter (receiver)?

Q:

10. Find a news article in a daily newspaper, and answer the following questions: (a) Does the information in the article support your views and attitudes or does it conflict with them? (b) Does the...

Q:

2. Give an example where information that is emotionally interesting, specific and close in time and space, can be used to capture someones interest.