Question: The joint is fastened together using two bolts. The factor of safety for shear is 2 . 5 . Determine the required diameter of the

The joint is fastened together using two bolts. The factor of safety for shear is 2.5. Determine the required diameter of the bolts if the failure shear stress for the bolts is fail=350MPa.
The joint is fastened together using two bolts.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

1) The joint is fastened together using two bolts. Determine the required diameter of the bolts if the allowable shear stress for the bolt is Tallowable = 110 MPa. Assume each bolt supported an equal...

Q:

The tension member is fastened together using two bolts, one on each side of the member as shown. Each bolt has a diameter of 0.3 in. Determine the maximum load P that can be applied to the member if...

Q:

The lap joint below is fastened together using a bolt having failure shear stress of 150 MPa. Determine the required cross-sectional area of the bolt to support a 60 kN applied load (P). Assume...

Q:

Determine the values of required parameters for a single shear lap joint and a double shear butt joint for given service conditions. Task 1 a) The diagram below shows a lap joint where two plates are...

Q:

T F a a 750 lb 1-38. The small block has a thickness of 5 mm. If the stress distribution at the support developed by the load varies as shown, determine the force F applied to the block, and the...

Q:

1-For a bolted assembly, two plates of cast iron are clamped together. Each cast iron assembly part has 0.75 inch thickness. The bolt isin 16UNF 2in SAE grade 5. (UNF-Fine Series). The bolt material...

Q:

The sign is 3 m x 2 m and will be subjected to a wind pressure of 0 . 7 kPa ( see Fig. 1 ( a ) ) . The sign is connected to a 1 0 m high support column which will be a circular hollow steel tube of...

Q:

Activity 6-3-Footing Forms Refer to Print 6-3 and Quantity Spreadsheet No. 6-3 in the online learner resources. Calculate the linear feet of metal forms required for the footings. In addition,...

Q:

Part2A, 2B, and Discussion I'll need answers, formulas, and work shown please. Part 2A Torsional Key Design Choose a key material from Table 02 above and document your choice of material and temper...

Q:

1. Choose a key material from Table 02 above and document your choice of material and temper in your work. I used Tin Brass (Sy= 55000posi, Su=6000 ksi, E=16000, elongation: 6%) Hardness 76) 2....

Q:

On December 31, 20--, Sanchez Company needed to record its accrued wages for year-end. If December 31 is a Wednesday, then Sanchez Company must account for three days of wages. The company operates...

Q:

Walter Industries has $5 billion in sales and $1.7 billion in fixed assets. Currently, the companys fixed assets are operating at 90% of capacity. a. What level of sales could Walter Industries have...

Q:

Brief Exercise 15-26 Preparing Common-Size Income Statements by Using Base Period Horizontal Analysis Refer to the information for Azita Company above. Required: Prepare common-size income statements...

Q:

Campbell, a single taxpayer, earns $418,000 in taxable income and $2,900 in interest from an investment in State of New York bonds. (Use the U.S. tax rate schedule.) Required: a. How much federal tax...