the question is complete. if you dont know how to answer it put your ego to the side and dont respond with "incomplete question" to deter others.

Suppose there is an order for 300 of gear shaft SG 123. The due date is day 160. The route sheet, shown in Figure 1, gives information about the operations to be performed and the setup and run times. The work center file, shown in Figure 2, gives lead time data for each work center. Calculate the start and finish dates for each operation. Use the following scheduling rules. IA a. Operation times are rounded up to the nearest 8 hours and expressed as days oka one-shift basis. That is, if an operation takes 6.5 standard hours, round it up to 8 hours, which represents one day. b. Assume an order starts at the beginning of the day and finishes at the end of a day. For example, if an order starts on day 1 and is finished on day 5, it has taken 5 days to complete. If move time is 1 day, the order will be available to the next workstation at the start of day 7. Cupce I UVERIN Iuay, we VII WII U avana w UE HIER WURD alte start of day 7 Figure 1: Routing file Part Name: Gear shaft Part Number: SG 123 Drawing Number: D123X Operation No. Work Center S/U Time (standard hours) Run Time/piece (standard hours 10 20 30 40 SO 12 14 17 03 Stores 1.50 0.50 0.30 0.45 0.20 0.25 0.05 0.10 Operation (days) Wait (days) Finish Date Figure 2. Lead time data from work center file. Operation Work Arrival Queue Number Center Date (days) 10 12 1 3 20 14 J. 5 30 17 K 2 40 03 L 3 50 Stores 160 . MOA 1 1 1 1 E E G . (a) Please fill in the blanks from A to L. (8 points) (b) The order must arrive at work center 12 on which day? (2 points) You can write down the procedure of calculation for problem 6 on this page