Question: The upper and lower specification limits for the width of a plastic component are 3 8 mm and 3 4 mm , respectively. 1 0

The upper and lower specification limits for the width of a plastic component are 38 mm and 34 mm, respectively. 10 samples of seven readings at random times showed that their average width was 35.6 mm and the average range was 1.9 mm. Determine if this process is capable or not. What fraction of components can be expected to be classified as defective?

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

Q:

What should you use to stratify discrete or categorical data? Boxplots Pareto charts Histograms Dotplots What should you use to stratify continuous data? main effects plots Pareto charts scatter...

Q:

Answer the question below based on the picture: (a) What are the upper and lower specification limits for this product? (b) If the process is known to operate at a mean thickness of 6.05 mm. What is...

Q:

The average demand for an independent component is 900 units per year. The ordering cost and inventory costs are $60 and $10, respectively. If the EOQ is used to be estimate the order-quantity, how...

Q:

If the standard deviation of a centered process is increased by 100%. The USL, LSL, and the mean of the process keep the same. Which of the following statements is TRUE? The process capability ratio...

Q:

Q1) Samples of size 4 were taken from a process that had a target of 25 ounces with upper and lower specification limits of 30 ounces and 20 ounces respectively. Using Type-I error alpha of 5% please...

Q:

Q1) Samples of size 4 were taken from a process that had a target of 25 ounces with upper and lower specification limits of 30 ounces and 20 ounces respectively Using Type-l error alpha of 0.26%...

Q:

Samples of size 4 were taken from a process that had a target of 25 ounces with upper and lower specification limits of 30 ounces and 20 ounces respectively. Using Type-I error alpha of 0.26% please...

Q:

Q1) Samples of size 4 were taken from a process that had a target of 25 ounces with upper and lower specification limits of 30 ounces and 20 ounces respectively Using Type I error alpha of 0.26%...

Q:

Q1) Samples of size 4 were taken from a process that had a target of 25 ounces with upper and lower specification limits of 30 ounces and 20 ounces respectively Using Type-terror alpha of 0.26%...

Q:

please answer this Listen The specification for a plastic liner for concrete highway projects calls for a thickness of 6.0 mm + 0.1 mm. The standard deviation of the process is estimated to be 0.02...

Q:

Where would you place H&M in terms of the four stances on social responsibility in Table 5.2 ?

Q:

During 2011, its first year of operations, Baginski Steel Corporation reported an operating loss of $375,000 for financial reporting and tax purposes. The enacted tax rate is 40%. Required: 1....

Q:

A nondired imighe Elerapy based on the work of Carl liogers in which the clent does all the taking and the therapst listens is called what? tree associscion modeling pernonceritered therapy...

Q:

Excey Corp. has 9 percent coupon bonds making annual payments with a YTM of 8.2 percent. The current yield on these bonds is 8.55 percent. How many years do these bonds have left until they mature?...