There are two errors at the end and I don't know how to fix it. It for a Pickit 3. Can you help?

#include #include #include #include #include #pragma config OSC = INTIO67 #pragma config WDT = OFF #pragma config LVP = OFF #pragma config BOREN = OFF #define delay 5 // Prototype Area to place all the references to the routines used in the program void Init_ADC(void); unsigned int Get_Full_ADC(void); void Flash_LED(unsigned char); void main(void) { unsigned int ADC_Result; // local variable to store the result Init_ADC(); // initialize the A2D converter TRISB =0x00; // make PORTB as all outputs while(1) { ADC_Result = Get_Full_ADC(); // call routine to measure the A2D port Flash_LED(ADC_Result); // call routine to flash the LED based on the delay // indicated by ADC_Result } } void Init_ADC(void) { ADCON0=0x01; // select channel AN0, and turn on the A2D subsystem ADCON1=0x0E; // set pin 2 as analog signal, VDD-VSS as reference voltage // and right justify the result ADCON2=0xA9; // Set the bit conversion time (TAD) and acquisition time } unsigned int Get_Full_ADC(void) { int result; ADCON0bits.GO=1; // Start Conversion while(ADCON0bits.DONE==1); // Wait for conversion to be completed (DONE=0) result = (ADRESH * 0x100) + ADRESL; // Combine result of upper byte and lower byte into return result; // return the most significant 8- bits of the result. } void Flash_LED(unsigned int ADC_result) { unsigned int counter1, counter2; LATB = 0x0A; // output to PORTB the pattern 00001010 // delay loop for (counter2=delay; counter2>0; --counter2) { for (counter1=ADC_result ; counter1>0; -- counter1); } LATB = 0x05 // output to PORTB the pattern 00000101 // delay loop for (counter2=delay; counter2>0; --counter2) { for (counter1=ADC_result ; counter1>0; -- counter1); } }