Question: Translating Your Histogram Your process has a normal histogram with located at 10 millimeters,1points at 9.9 and 10.1 millimeters,2points at 9.8 and 10.2 millimeters, and3points

Translating Your Histogram

Your process has a normal histogram withlocated at 10 millimeters,1points at 9.9 and 10.1 millimeters,2points at 9.8 and 10.2 millimeters, and3points at 9.7 and 10.3 millimeters.

If your customer will accept parts measuring between 9.7 and 10.3 millimeters, how many parts of every 1,000 produced would you expect to scrap? If your customer notified you that henceforth it would accept only parts between 9.9 and 10.1 millimeters, what would you anticipate your scrap rate to be? What would have to be done to bring the scrap rate at this new customer requirement back down to what it had been at the former customer specification? Compared with the bell curve above, what would the new histogram have to look like?

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!